European manufacturing
0203 445 0659
vibrator@casadio.fr
ACBMV CASADIO VIBRATION 3 Z.A. LES PRAIRIES38290 FRONTONAS - FRANCE
0203 445 0659
The MVCC series of vibrators in direct current has been designed for use in those situations where network electricity is not present. In particular for hoppers, silos and gate-controls and roll-on roll-off vehicles (concrete mixers, pumps for concrete, plasterers, salt distributors, gravel spreader, fertiliser spreader, hauled silos, industrial sweeper filters). The newly-conceived electric motor, with permanent magnet poles, and the increase in size of the electrical parts, allow constant, high yielding performance. The MF models have a multi-hole fixing base to adapt to different centre distances of drilling.
In direct current at 12 or 24V.
Electromagnetic compatibility 2004/108/EC, Low Voltage 2006/95/EC.
Continual service (S1) at maximum declared centrifugal force and electric power. Intermittent services are also possible depending on the type of vibrator and our operating conditions. For detailed information contact our technical assistance office.
Range extended up to 1520 Kgf. (14,9 KN), with centrifugal force adjustable from 0 to 100%.
IP 66 according to IEC 529, EN 60529.
IK 08 according to IEC 68, EN 50102.
From -20°C to +40°C.
In all positions and therefore without restriction.
Sealed ball bearings, lubricated “for life”.
On MF models it’s positioned underneath the vibrator, on the same side as the fixing base.
Direct current with permanent magnet poles. The rotor is a wound brush-type with collector.
In high-tensile aluminium alloy.
Constructed in aluminium with steel bearing seat. The geometry of the flange transmits the load to the casing uniformly.
In treated steel alloy (Isothermic hardening) resistant to stress.
Enable continuous adjustment of the centrifugal force. This adjustment is facilitated by a graduated scale that expresses the maximum centrifugal force. A patented system (patent N°MO98A000194) called ARS prevents adjustment errors.
In alluminum alloy for models 3/100-MF, 3/200-MF and 3/500; in AISI 304 stainless steel for models 3/1200 and 3/1500.
Electrostatic surface treatment based on polymerised epoxy polyester powder in oven at 200°C. Tested in salt spray for 500 hours.
All MVCC electric vibrators have been tested in semi-anechoic chamber to verify conformity with the standards and directives on electromagnetic compatibility. The MVCC series is supplied with a special high-resistance synthetic rubber power supply cable measuring 2.5 m.
Mechanical protection IP66 (EN 60529), protection against impacts IK 08 (EN 50102)
Certificate GOST-R n° POCC IT.AH50.B13978, Regulation GOST R 50615, GOST 17770, GOST 12.2.030, GOST R 51318.14.1, GOST R 51318.14.2, GOST R 51317.3.2, GOST R 51317.3.3.
Comply with the applicable European Union directives